\

 

 

 

 

Daisy PinText Box: Supplies: 5 3” flexible bugle beads 28” of 26g wire silver 1 metal ring 1 round pin back Glue-hot glue Glue-a longer setting glue for metal and plastic

Text Box: 1. Pick up one 3” bugle and place on wire appx 5” from one end of the wire.  This will be the “short end” of the wire.  Wrap the short end and the long end around the jump ring 2 times.   2. Pick up a second 3” bugle.  Wrap the long end of the wire around the ring 2 times   3.Continue putting on bugles until you have 5 petals as shown in picture.

Text Box: 4. Working with the long end of the wire, wrap it around the jump ring several times in between the petals until it is at the opposite end of the metal ring from the short end of the wire.

Text Box: 5. Mount the MyELEMENTS flower onto the front by passing each wire through each of the 2 holes in the ELEMENT flower.

Text Box: 6. Secure ELEMENT and finish off wire by wrapping each of the wires around the jump ring several more times.   7. Cut the ends of the wire and push them into the center of the ring.   8. Add round pin back using a strong glue made to hold to metal and plastic.  Apply this generously to pin back first and then put a small drop of hot glue into the center of the jump ring and onto the back of the flower.  This will hole the pin back in place while the  second glue dries for 24 hrs.